48
2. Using any parts other than the original
ones will immediately cause the man-
ufacturer’s liability for material defects
and/ or the manufacturer
’s warranty
service to become void. There is also
an increased risk of accidents or falls.
3.
The safe functioning of your FLYER
can only be guaranteed with regular
maintenance. Maintenance work may
only be performed by FLYER special
-
ist retailers.
Monthly
–FLYERdriver
Checkthat allscrews, nuts,quickrelease axles
andquickreleasefastenersarermlyattached
Everyyearorafterevery1000km,whichever
occursrst
FLYER specialist retailer
• Lubrication of all moving parts for which lubri
-
cation
isintended(excludingbrakesurfaces)
• Visual inspection of the frame and of
components for cracks and damage
•
Mend paint damage
• Replace parts with rust spots
• Treatallbaremetalparts(excludingbrakesur
-
faces) against corrosion (rust)
•
Change defective or damaged parts
• Check the wheels and centre them as required
• Check the tension of the spokes
• Check and clean the chain/sprocket/cogset
• Lubricate the chain with a suitable lubricant
• Check the rim for wear
• Check the brake pads for wear
• Checkthatallscrews,nuts,quickreleaseaxles
andquickreleasefastenersarermlyattached
• Checkthebrakesystemandquickreleaseax
-
les and adjust it or replace parts if necessary
•
Check the gear system and adjust or replace
parts of it if necessary
• Check the hubs
• Check the headset
• Check the pedals
1. Only use cleaning agents and lu
-
bricants that are recommended or
approved by the component
manu-
facturer.
2.
Please note that not all lubricants and
care products are suitable for your
FLYER. By using unsuitable lubri
-
cants or care products, you can dam-
age or impact the functionality of your
FL
YER e-bike.
Ensure that the brake pads, brake discs
andbrake surfacesarenot exposedto
cleaningorservicinguidsoroils,asthis
reduces the performance of the brakes.
23.1 Maintenance work and ex-
changeofwearingparts
1. Components to be changed may only
be replaced with identical, original
parts. Wearing parts may only be
replaced with identical, original com
-
ponents.