FLYGT 3202 - Change the Coolant; Empty the Coolant

Property
class
M4 M5 M6 M8 M10 M12 M16 M20 M24 M30
100 4.1 (3) 8.1 (6) 14 (10) 34 (25) 66 (49) 115 (84.8) 248 (183) 481 (355) — —
Table 2: Steel, torque Nm (ft-lbs)
Property
class
M4 M5 M6 M8 M10 M12 M16 M20 M24 M30
8.8 2.9 (2.1) 5.7 (4.2) 9.8 (7.2) 24 (18) 47 (35) 81(60) 194 (143) 385 (285) 665 (490) 1310
(966.2)
10.9 4.0 (2.9) 8.1 (6) 14 (10) 33 (24) 65 (48) 114 (84) 277 (204) 541 (399) 935 (689) 1840
(1357)
12.9 4.9 (3.6) 9.7 (7.2) 17 (13) 40 (30) 79 (58) 136 (100) 333 (245) 649 (480) 1120
(825.1)
2210
(1630)
Hexagon screws with countersunk heads
For hexagon socket head screws with countersunk head, maximum torque for all property
classes must be 80% of the values for property class 8.8 above.
Change the coolant
This image shows the plugs that are used to change the coolant.
1
2
2
Figure 24: With a cooling jacket
1
2
2
WS001480A
Figure 25: Without a cooling jacket
1. Inspection plug
2. Coolant plugs
Empty the coolant
WARNING:
The seal housing may be pressurized. Hold a rag over the inspection/ filling plugs to
prevent splatter.
1. Empty the coolant in the inspection chamber:
a) Remove the inspection plug.
Maintenance
42 Flygt 3202 Installation, Operation, and Maintenance Manual