Program Program
Code Function Code Description Entry Code
Issue/Rev. 0.3 (8/97) 21
100 System General Purpose Directory 100
101 System Alarm Check/Reset Read only, Press E to clear None 101
Available Alarms
A2: Print Cover Open E4: Printer Error
A4: Print Cover Open F1: Add 1 Feedback
B2: Buffer Overflow F2: Add 2 Feedback
B4: Buffer Overflow F3: Add 3 Feedback
CL: Clean Line F4: Add 4 Feedback
CM: Communication F5: Add 5 Feedback
DA: EEProm Bad F6: Add 6 Feedback
DA: Ram Bad F7: Add 7 Feedback
DA: Rom Uxx Bad F8: Add 8 Feedback
DA: Watchdog Alarm H2: Printer Hardware
DA: Display Error H4: Printer Hardware
DA: Data Retention I2: Printer Not Responding
DA: Display Boot Required I4: Printer Not Responding
DA: Control Module OA: Overrun
DA: Security Code O2: Printer Paper Out
DA: Software Version O4: Printer Paper Out
DA: Internal Temperature PA: Power Failure*
DA: Keypad Alarm P2: Printer Communication
DA: Keypad Mismatch P4: Printer Communication
DA: Program Code SF: Storage Full
D2: Printer Deselected SP: Shared Printer
D4: Printer Deselected TK: Ticket Alarm
E2: Printer Error ZF: Zero Flow**
*Note: This alarm applies to RBU-07 and above firmware only.
**Note: This alarm applies to RBU-08 and above firmware only.
102 Product 1 Alarm Check/Reset Read only, Press E to clear None 102
Available Alarms
BH: Blend High LF: Low Flow
BL: Blend Low LP: Low Pressure
BP: Back Pressure LT: Low Temperature
CF: Not Configured Flow OA: Overrun
DA: Program Code PR: Pressure Transducer
DR: Density Transducer PS: Pulse Security
HD: High Density PT: Pulse Transmission Alarm
HF: Excess High Flow TP: Temperature Probe
HP: High Pressure UF: Unauthorized Flow
HT: High Temperature VF: Valve Fault
LD: Low Density ZF: Zero Flow
To Next Page
Loading...
