44
Installation and Operation Manual
SystemsSystems
2001 and 2002
Hypro Corporation, as supplier of FoamPro, warrants to the original purchaser, each new pump, system or other product of its own
manufacture, for a period of one year from the date of shipment from the factory, to be free from defects in material and workmanship
under normal use and service. “Normal use and service” means not in excess of recommended maximum speeds, pressures, and
temperatures, or handling fluids not compatible with components materials, as noted in applicable Hypro Corporation product
catalogs, technical literature, and instructions. This warranty shall not apply to any pump, system or other product which shall have
been repaired or altered to adversely affect the performance or reliability of the pump, system or other product.
Neither this warranty nor any implied warranty apply to damage or harm caused by any or all of the following: (1) Freight damage; (2)
Freezing damage; (3) Damage caused by parts and/or accessories or components not obtained from or approved by Hypro
Corporation; (4) ANY CONSEQUENTIAL OR INCIDENTAL DAMAGES, OTHER THAN INJURY TO THE PERSON, ARISING FROM
THE USE OF ANY PUMP OR OTHER PRODUCT MANUFACTURED BY HYPRO CORPORATION EXCEPT in states that do not
allow the exclusion or limitation of incidental or consequential damages; (5) Damage due to misapplication and/or misuse; (6) Normal
wear of moving parts or components affected by moving parts.
The liability of Hypro Corporation under the foregoing warranty is limited to the repair or replacement at Hypro Corporation’s option
without charge for labor or materials of any parts upon return of the entire pump, system or other product or of the particular part to the
Hypro Corporation factory within the warranty period, at the sole expense of the purchaser, which part shall upon examination appear
to Hypro Corporation’s satisfaction to have been defective in material and workmanship.
The liability of Hypro Corporation under any theory of recovery (except any express warranty where the remedy is set forth in the
above paragraph) for loss, harm or damage, shall be limited to the lesser of the actual loss, harm or damage or the purchase price of
the involved pump, system or other product when sold by Hypro Corporation to its customer.
Hypro Corporation expressly warrants its pumps and other products as above stated. THERE ARE NO OTHER EXPRESS
WARRANTIES. ANY IMPLIED WARRANTIES, INCLUDING IMPLIED WARRANTY OF MERCHANTABILITY OR OF FITNESS FOR A
PARTICULAR PURPOSE, ARE LIMITED IN DURATION TO ONE YEAR FROM THE DATE OF PURCHASE BY THE ORIGINAL
PURCHASER EXCEPT in states that do not allow time limitations on implied warranties. THERE IS NO IMPLIED WARRANTY OF
FITNESS FOR A PARTICULAR PURPOSE OR MERCHANTABILITY WHEN THIS PRODUCT IS PUT TO RENTAL USE.
No person including any dealer or representative of FoamPro is authorized to make any representation or warranty concerning Hypro
Corporation's FoamPro products on behalf of Hypro Corporation, or to assume for Hypro Corporation the obligations contained in this
warranty. Hypro Corporation reserves the right to make changes in design and other changes and improvements upon its products
without imposing any obligations upon itself to install the same, upon its existing products then in process or manufacture.
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
IMPORTANT NOTICE
It is imperative to package all FoamPro components properly, before shipment (with Return Goods
Authorization attached) back to Hypro Corporation. The FoamPro contains electronic components that may
receive damage from improper shipping procedures! All FoamPro components shipped back to Hypro will
pass through Quality Control Inspection, and will be photographed after the box is opened. Any shipping
damage, such as superficial scratches, nicks, etc., to the unit makes it unusable (even after the internal
warranty problem is repaired) and thus must be refinished to “like-new” condition during the warranty
process.
You are responsible for any physical damage occurring to FoamPro components at your facility and
during shipment back
to Hypro.
Package the FoamPro, complete with all the recommended parts the Customer Service representative
requires (i.e., Digital Display control with all premolded wire cables etc.) in its original carton with the
Styrofoam and other packaging materials, as it was received at your facility.
Hypro Corporation appreciates your attention in this matter, as we feel it will help us to serve you in a better
fashion, while keeping the cost of the FoamPro product competitive. Thank you.
WARRANTY
15
To Previous Page
Loading...