Note: Handle a halogen headlamp bulb
carefully and keep out of children’s reach.
Handle the bulb only by its plastic base and
do not touch the glass. The oil from your
hand could cause the bulb to break the next
time the headlamps are operated.
Note: If the bulb is accidentally touched,
clean it with rubbing alcohol before
installing it.
Accessing and Replacing the High
Beam Headlamp Bulbs
1. Make sure the headlamps are off.
2. Remove the scrivet from the modesty
panel.
3. Remove the modesty panel section.
4. Remove the scrivet from the front
fender and the hardware from the
bolster.
5. Using a screwdriver loosen, but do not
remove, the three screws by turning
them two full turns.
6. Carefully slide the headlamp assembly
forward approximately 1.2 in
(30 mm),do not remove the headlamp.
Be careful of the sharp fender edge, as
it could damage the headlamp.
421
2024 Ranger (TRD) Canada/United States of America, enUSA, Edition date: 202304, DOM
Maintenance
To Next Page
Loading...
