config system pstn FortiGate Voice VoIP, PBX, and PSTN CLI Reference
FortiGate Voice Version 4.0 Administration Guide
44 01-400-112851-20100127
http://docs.fortinet.com/ • Feedback
set dtmf-method {auto | inband | info | rfc2833}
set codec {alaw | g729 |none | ulaw}
set codec1 {alaw | g729 |none | ulaw}
set codec2 {alaw | g729 |none | ulaw}
end
config system pstn
Use this command to configure the PSTN interfaces.
Syntax
config system pstn
edit <fxo_name>
set cid-name <caller_name>
set cid-name <caller_name>
set echo-cancel {enable | disable}
set status {enable | disable}
set user-callerid {enable | disable}
set cid-signalling {bell | dtmf | v23 | v23-jp}
set cid-start {polarity | ring}
set send-callerid-after <integer>
Variables Description Default
edit <provider_name> Enter the VoIP provider’s name. No
default
server
<server_address>
Enter the address for the server. The server’s address can
be either a domain name or an IP address.
No
default
user <user_name> Enter the user name for the provider. You can enter the
phone number registered with this provider instead.
No
default
secret <password> Enter the password associated with the provider. No
default
authuser <authuser> Enter the authentication user for the account. No
default
display-name
<display_name>
Enter the name that will be used as the caller ID name if
the provider supports this feature.
No
default
reigstration-
interval
<refresh_interval>
Enter a number for the refresh interval. No
default
account-type
{static | dynamic}
Enter to define the type of account. No
default.
port <port_provider> Enter the port that the provider will be using. No
default
dtmf-method {auto |
inband | info |
rfc2833}
Enter the DTMF method that will be used. No
default
codec {alaw | g729
|none | ulaw}
Enter the preference type for the first Codec. No
default
codec1 {alaw | g729
|none | ulaw}
Enter the preference type for the second Codec. No
default
codec2 {alaw | g729
|none | ulaw}
Enter the preference type for the third Codec. No
default