System configuration
FortiGate-100 Installation and Configuration Guide 131
To set the Auth timeout
1 For Auth Timeout, type a number in minutes.
2 Select Apply.
Auth Timeout controls the amount of inactive time that the firewall waits before
requiring users to authenticate again. For more information, see “Users and
authentication” on page 173.
The default Auth Timeout is 15 minutes. The maximum Auth Timeout is 480 minutes
(8 hours).
To select a language for the web-based manager
1 From the Languages list, select a language that the web-based manager uses.
2 Select Apply.
You can choose from English, Simplified Chinese, Japanese, Korean, or Traditional
Chinese.
To modify the Dead Gateway Detection settings
Modify dead gateway detection to control how the FortiGate unit confirms connectivity
with a ping server added to an interface configuration. To add a ping server to an
interface, see “Adding a ping server to an interface” on page 111.
1 For Detection Interval, type a number in seconds to specify how often the FortiGate
unit tests the connection to the ping target.
2 For Fail-over Detection, type a number of times that the connection test fails before
the FortiGate unit assumes that the gateway is no longer functioning.
3 Select Apply.
Note: When the web-based manager language is set to use Simplified Chinese, Japanese,
Korean, or Traditional Chinese, you can change to English by selecting the English button on
the upper right of the web-based manager.
To Next Page
Loading...
Need help?
General