Fostex CR500 - CR500 Technical Specifications

94
CD-R/RW MASTER RECORDER CR500 (Specifications)
CR500 main specifications
* 0dBu = 0.775Vrms, 0dBV = 1Vrms
Reference level: -12dBFS/-20dBFS (default: -12dBFS, selectable in the “Ref.Level” menu item of the SYS
SETUP menu)
ANALOG INPUT L, R (balanced)
Connector : XLR-3-31 type (balanced, pin-2: hot)
Input impedance : 10kΩ or higher
Reference input level : +4dBu
Maximum input level : +24dBu (-20dBFS)
ANALOG INPUT L, R (unbalanced)
Connector : RCA pin jack
Input impedance : 10kΩ or higher
Reference input level : -10dBV
Maximum input level : +10dBV (-20dBFS)
ANALOG OUTPUT L, R (balanced)
Connector : XLR-3-32 type (balanced, pin-2: hot)
Output load impedance : 10kΩ or higher
Reference output level : +4dBu
Maximum output level : +24dBu (-20dBFS)
ANALOG OUTPUT L, R (unbalanced)
Connector : RCA pin jack
Output load impedance : 10kΩ or higher
Reference output level : -10dBV
Maximum output level : +10dBV (-20dBFS)
PHONES
Connector : ø6mm Stereo Phone jack
Output load impedance : 8Ω or higher
Maximum output level : 100mW (32Ω)
DIGITAL INPUT
Connector : XLR-3-31 type (balanced, pin-2: hot)
Format : IEC 60958 (S/P DIF) or IEC 60958 (AES/EBU), auto
selection.
DIGITAL OUTPUT
Connector : XLR-3-32 type (balanced, pin-2: hot)
Format : IEC 60958 (S/P DIF) or IEC 60958 (AES/EBU),
The format of an output signal is selected in the “Digital
Out” menu item of the SYS SETUP menu.
USB (USB keyboard Only)
Connector : USB series “A” receptacle
The keyboard uses Default Scan Code 2.
GPI (Fader Start)
Connector : ø6mm Phone jack
Inputs/Outputs