15
1. [MAIN OUT (L/1, R/2)] connectors
These connectors output the stereo buss (L, R) sig-
nals or input channel 1 and 2 signals. You can se
-
lect the output signals by using the SOURCE SEL
switch. You can select the reference output level
using the MIAIN OUT level select switches.
Connector: XLR-3-32 type
2. MAIN OUT level select switches
Each switch selects the output level of the [MAIN
OUT] L/1 or R/2 connector. You can select the
reference level of these connectors independently
from +4 dBu, 0 dBu, -10 dBu and -60 dBu.
3. [SUB OUT (L/3, R/4)] connectors
These connectors output the stereo buss (L, R) sig
-
nals or input channel 3 and 4 signals. You can select
the output signals by using the SOURCE SEL switch.
You can select the reference output level using the
SUB OUT level select switch.
Connector: XLR-3-32 type
1
2
3
GND
HOT
COLD
4. SUB OUT level select switches
This switch selects the output level of the [SUB
OUT] (L/1 and R/2) connectors. You can select the
reference level of these connectors from +4 dBu, 0
dBu, -10 dBu and -60 dBu.
5. Battery compartment
You can set the battery box that houses eight AA
alkaline or nickel hydride batteries (see page 6).
When you use internal battery power, set the
[POWER]
switch to “INT”.
6. [EJECT/LOCK] lever
This lever locks or unlocks the battery box.
When you remove the battery box, slide down this
lever to unlock the battery box (see page 6).
7. AUX OUT level select switch
This switch selects the output reference level of the
[AUX OUT (1, 2)] jacks between -10 dBV and -60
dBV.
8. AUX OUT select switch
This switch selects the output signal sources of the
[AUX OUT (1 and 2)] jacks.
• OFF: No signal is output from AUX 1 and 2.
• L/R: Stereo (L and R) buss signals are output from
AUX 1 and 2.
• L+R: Stereo (L and R) buss signals are mixed and
output from AUX 1 and 2 in mono.
• 1/2 3/4: The post-fader signals of input channels 1
and 2 are output from AUX 1, while the post-fader
signals of input channels 3 and 4 are output from
AUX 2.
9. [AUX OUT (1, 2)] jacks
These jacks output the signals selected by the AUX
OUT select switch described above.
Connector: 3.5 mm stereo mini-phone jack
Right side panel
1
2
3
GND
HOT
COLD
To Next Page
Loading...
