v Manual Recording
Some channels, for example radio channels, do not provide
programme listings in the i-search banner or TV Guide. However,
you can still use the FOXTEL iQ2 to record these channels, by using
the Setup screens to set up the recording.
u First, press the active button on the remote control to display
the Active menu, then press D to highlight ‘System Setup’
and press select. The Setup screen displays (see also page 56).
u Press D to highlight ‘Manual Recording’ then press select.
The Manual Recording screen displays.
You set up the recording as follows:
1. Choose the channel to record, by either using the number
buttons to enter a channel number, or by using L or R to
look through the channel names.
2. Press D to highlight ‘Day’, then use L or R to select the day
on which you want to record the channel you have chosen.
3. Press D to highlight ‘Start Time’, then use the number
buttons to enter the time you want the recording to start. You
should use the ‘12-hour clock’, then use L or R to choose
AM or PM. For example, to record from 7:30 in the evening,
enter ‘0 7 3 0’ then choose ‘PM’.
While ‘Start Time’ is highlighted, if you make a mistake, you
can press back to delete the numbers you have entered and
start again.
4. Press D to highlight ‘End Time’, then, in the same way as you
entered the Start Time, use the remote control to enter the
time you want the recording to finish.
FOXTEL DIGITAL GUIDE
45
Recording programmes
To Next Page
Loading...