FOXTEL iQ2
81
FOXTEL iQ2
v Connections to the FOXTEL iQ2
The connection diagram is shown on page 82.
WARNINGS
Always disconnect the FOXTEL iQ2 from the power supply before
you connect it to (or disconnect it from) any other equipment.
The only way to disconnect the FOXTEL iQ2 from the power supply
is to remove the power lead. The FOXTEL iQ2 must therefore
be installed near to the power point, which should be easily
accessible.
The supplied power lead has a 2-way connector at one end and a
plug at the other. You should always insert the 2-way connector
into the FOXTEL iQ2
before
you insert the plug into the power
supply.
Do not connect the plug to the power supply until you have made
ALL the other connections.
The FOXTEL iQ2 operates with a 240 V AC, 50 Hz power supply.
Do not connect it to a DC power supply.
If you are in any doubt about the power lead, its plug or its
connection, consult a qualified electrician.
To Next Page
Loading...