SETUP
73
Setup
Audio and Language Settings
The standard (default) setting for each item is marked with *.
To confirm any changes, highlight ‘Save New Settings’ then press
select, or to cancel, press back.
If you press the red (Reset all settings) button, the settings will
change to the
standard
settings (
NOT
the settings made by your
installer).
Item Settings Comments
Audio output Stereo*, Mono Controls the audio output of the FOXTEL iQ2.
Background music Off, Live, Music* Controls whether or not music or Background Live Audio will play
while you look at the FOXTEL Guide.
Incorrect PIN signal On*, Off Controls whether or not a ‘beep’ noise will sound if you enter an
incorrect PIN.
HDMI Digital Audio
Output
MPEG*, AC3 Controls the digital audio output from the HDMI connector.
SPDIF Digital Audio
Output
AC3*, MPEG Controls the digital audio output from the connectors marked
‘OPTICAL AUDIO OUT’ and DIGITAL AUDIO OUT’. Select AC3 if your
equipment has Dolby Digital decoding capabilities. The setting
‘MPEG’ is for digital stereo sound.
Note: Dolby Digital is only available on some programmes. If Dolby
Digital is not available, the audio output will be digital stereo.
SPDIF Digital
Audio Delay
0ms*, 10ms,
20ms, 30ms,
40ms, 50ms,
60ms, 70ms,
80ms, 90ms,
100ms
Televisions take time to process a Digital HDMI input, this can
result in the audio being ahead of the video if an external
Dolby Digital decoder is being used. This setting allows you
to delay the audio to match up with the video.
Preferred Language English Choose your preferred language for programmes or channels where
more than one language is available.
* Indicates Default Setting
To Next Page
Loading...