Foxtel iQ2 - Energy Saving Level

SETUP
67
Setup
Energy Saving Level
The Energy Saving Level puts the iQ2 into standby then spins down
the hard disk to reduce the power consumption by the iQ2. There are
three modes (‘Low’, ‘Medium’, ‘High’) which determine how long
the iQ2 will be idle before it goes into standby and spins down the
hard disk. The hard disk will automatically spin back up for recordings
which will be unaffected.
1. Press the active button on the remote control to display the
Active menu, then highlight ‘Setup’ and press select
2. Highlight ‘FOXTEL iQ2 Setup’, then press select
3. Highlight ‘Energy Saving Level’ and use the L and Rbuttons to
select the level you would like.
4. Highlight ‘Save New Settings’ and press select.
Before the iQ2 goes into standby the following message will appear
onscreen.