GETTING STARTED
7
Getting started
v Switching the FOXTEL iQ2 on and off
Whenever you are not using the FOXTEL iQ2 you should put it into
standby. You should not unplug it at the power point.
u To put the FOXTEL iQ2 into standby, press S.
The standby light on the front panel shines red.
u To take the FOXTEL iQ2 out of standby and switch it on, press
FOXTEL on the remote control (or S again).
Note
You can also press tv guide, on demand, active or planner to
take the FOXTEL iQ2 out of standby.
v Changing channel
You can change the channel by using:
u the ch + and ch - buttons;
u the number buttons (channel numbers are always three
digits, for example 108);
u the back button to remove any onscreen display, then, when
the screen is clear, press the back button again to take you to
the previous channel you were viewing; or
u the FOXTEL Guide described in the later sections.
When you change channel, a banner (the
i-search banner
) displays
briefly to show information about the channel. It automatically
disappears after a few moments, or you can press back to remove
it immediately.
For more information about the i-search banner, see page 11.
Blocked channels
Sometimes you might change channel to a blocked channel or
programme. This means the channel or programme has been
restricted by your Parental Control settings, so you will not be
permitted to view it simply by changing channel to it.
To unblock the channel or programme, you will need to enter your
PIN. For more information, see page 58.
v Changing the volume
u To change the volume, press vol + or vol -.
u To turn the sound on or off, press mute.
To Next Page
Loading...