For your safety
6
Using the FOXTEL iQ2
The FOXTEL iQ2 has been manufactured to meet international safety
standards. To obtain the best results and operate the FOXTEL iQ2 safely it is
important that you read the safety instructions below.
If you have any doubts about the installation, operation or safety of the
FOXTEL iQ2, please consult FOXTEL.
WARNING!
Remember that contact with 240 V AC power can be lethal or can
cause a severe electric shock. To avoid this risk:
Never remove the top cover from the FOXTEL iQ2 as there are
high-voltage live parts inside. There are no user-serviceable
parts inside the FOXTEL iQ2.
Make sure that all electrical connections are safe and secure.
Do not connect any of the equipment (FOXTEL iQ2, TV, video
recorder etc.) to the power supply until you have properly
connected all the other leads.
Disconnect the FOXTEL iQ2 from the power supply (by
disconnecting its power lead from the power point on the wall)
before you disconnect any other equipment from its rear panel.
Never push anything into the holes, slots or other openings of
the FOXTEL iQ2 case (except the FOXTEL Smartcard into its correct
slot).
CAUTION!
✔ To ensure a free flow of air around the FOXTEL iQ2, allow as an absolute
minimum 10cm clearance on sides and 15cm clearance on top of the
FOXTEL iQ2.
Note: The recommended clearances are 10cm clearance on sides and
15cm clearance on top of the FOXTEL iQ2.
✔ If the FOXTEL iQ2 is placed with other items of audio/video equipment
in a cabinet, make sure all items have sufficient space all around them,
to allow ventilation and prevent overheating.
✘ Do not install the FOXTEL iQ2vertically, install only in horizontal
orientation.
✘ Never stand the FOXTEL iQ2 on soft furnishings or carpets. Do not cover
any ventilation slots.
✘ Do not place the FOXTEL iQ2 in an unventilated cabinet or on top of a
unit which emits heat (e.g. a TV).
✘ Do not stack items of audio/video equipment in a crowded space.
✘ Do not use or store the FOXTEL iQ2 in hot, cold, damp or dusty places.
✘ Do not put anything on the FOXTEL iQ2 which might melt, drip or spill
into it. Never stand objects filled with liquids, such as vases, on top of
the FOXTEL iQ2.
✘ Never place naked flame sources, such as lighted candles, on top of the
FOXTEL iQ2.
✘ Do not pick up or otherwise move the FOXTEL iQ2 while it is connected
to the mains supply. If you want to move the FOXTEL iQ2, first
disconnect it, then wait at least 30 seconds before continuing.
To Next Page
Loading...