17
NT530 Plus User’s Manual_English_V1.03
Figure 4-10 Sample Code Screen
4.1.3.2 Clear Codes
Erase Codes menu lets you to clear all current and stored DTCs from a selected control module. Also it erases
all temporary ECU information, including freeze frame. So make sure that the selected system are completely
checked and serviced by technicians and no vital information will be lost before clearing codes.
NOTE
● To clear codes, make sure that the ignition key is switched to ON with the engine off.
● Erase Codes does not fix the problem that caused the fault! DTCs should only be erased after correcting the
condition(s) that caused them.
To clear codes:
1. Scroll with the arrow keys to highlight Clear Codes from Function Menu and press the ENTER key.
Figure 4-11 Sample Function Menu Screen
2. Follow the on-screen instructions and answer questions about the vehicle being tested to complete the
procedure.
To Next Page
Loading...
