10
T1000 TPMS Service Tool Manual_English_V1.01
4 Battery Charger - charges built-in battery via wall plug.
5 Blower Molding Case - stores the TPMS Service Tool and its accessories.
6 Warranty Card - A warranty card is required if you need any repair or replacement from us.
2.2.3
Technical Specifications
Display: Backlight, 240*320 TFT color display
Working Temperature: 0 to 60 ℃ (32 to 140℉)
Storage Temperature: -20 to 70℃ (-4 to 158℉)
Power Supply: 3.7V/2200mAH Li-polymer battery, 3.3V USB power
Dimensions (L*W*H): 200*100*38mm
Gross Weight: 1.6kg
Radio reception: 315 MHz and 433 MHz
3 Getting Started
This section describes how to provide power to the TPMS service tool. It provides a brief
introduction of applications loaded on the TPMS Service Tool, an introduction of symbol and
icons displayed on the screen and how to power on/off and charge the tool.
3.1 Power on/off the TPMS Service Tool
The T1000 is powered on/off by pressing the power switch.
To power on/off the tool
1. Press the power switch to power on the tool, and the unit will display the Main Menu.
2. Hold the power switch for one 1 seconds and the release to power down the T1000. The tool
powers down automatically after a period of inactivity. Please refer to 7.4 Auto Power-off
Interval for details.
3.2 Charging the TPMS Service Tool
The T1000 is shipped with fully charged battery, but due to self-drain it may require charging, it is
recommended to charge the tool over 3 hours before first use.
The unit charges on any of the following sources
●
12-volt wall plug
●
USB connection to personal computer
IMPORTANT
Use the battery charger or USB cable included in the T1000 tool kit ONLY. The use of un-
approved power supplies may damage the tool and will void the tool warranty.
3.2.1
Charging via Wall Plug
To charge via wall plug
1. Find the power port at left side of the tool.
2. Connect the tool to power source with the battery charger provided.
3.2.2
Charging via Personal Computer with USB Cable
To Next Page
Loading...