20
T1000 TPMS Service Tool Manual_English_V1.01
2. Select Programming--Clone by Activation from the available menu.
3. Place the tool near the original sensor to be copied and press Activate to continue.
4. After trigger successfully, press Y to continue.
Figure 4-15 Sample Activation Screen
5. Place a new Foxwell sensor near the TPMS tool (around 0-20 cm).
Figure 4-16 Sample Activation Screen
6. Press Y to start the programming when the tool detect the sensor.
7. Press N to exit after the programming successfully.
Figure 4-17 Sample Activation Screen
5.3.3 Automatic Create (1-16 sensors)
To Next Page
Loading...