PostBase Mailing System
60
• Arrange the letter stack so that all envelope
flaps are face down.
• Make sure the letters are flush at their
upper sides: Loosen letter stack with the
upper edge on a level base and shake
smooth.
Pendulum
For reliable results, use the ‘pendulum’ when
franking bent or thin letters in stack. It
presses down the letters so that the sensors
can recognise them.
• Raise the pendulum.
• Position the letter stack:
– side to be printed face up (address field
is visible)
– the top edge must touch the letter guide
face
– observe the maximum stack height of
55 mm (2.2").
• Move the letter guide so that the letter
guide rests against the letter stack.
To Next Page
Loading...