Part No. 22958 Rev. P June 2017 - 18 - Fusion, Food & Beverage Cabinet
INSTALLATION
Regulations
COMBINED FOOD & BEVERAGE CABINETS
-
INSTALLATION
Compliance
with Local
Requirements
It is very important that your door-less cabinet is installed correctly and that the
operation is correct before use. Installation must comply with local electrical,
health & safety and hygiene requirements.
The appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety. Children should
be supervised to ensure that they do not play with the appliance.
Preparation
COMBINED FOOD & BEVERAGE CABINETS
-
INSTALLATION
Unpack and check unit for damage and report any damage to the carrier and
supplier.
The cabinet is supplied fully assembled. Report any deficiencies to your
supplier.
Remove all tapes, ties and packers, used to prevent movement during transit.
Lift out the deck trays and grills to gain access to the cabinet well.
Before connecting to the power supply, check that the local supply is correct to
that shown on the rating plate, located on the rear of the cabinet.
WARNING-THIS APPLIANCE MUST BE EARTHED/GROUNDED
Cabinets will usually be earthed via the earth conductors in the three core mains
leads of the refrigerated and heated cabinet sections.
An externally accessible terminal is also provided for bonding cabinets together
and to earth.
To Next Page
Loading...