Franke F3D3SP - Daily Procedure for Starting Up;Switching on

19
07/2 0 15
i
Frozen fry dispenser F3D3S/F3D3/ F3D3SP/F3D3P
en
. DAILY PROCEDURE FOR STARTING UP/SWITCHING
ON
Assembling the appliance
NOTICE
Appliance damage!
Components that are frozen together may damage the appliance.
- Never place wet components into the freezer.
NOTICE
Appliance damage!
Rinsing with water that is too hot can deform the hopper(s).
- Clean the hopper(s) with lukewarm water only.
Components that are frozen together may damage the appliance.
- Never place wet components into the freezer.
- Carefully dry the components after cleaning.
- Wash and disinfect all components in the rinsing sink one after the other.
- Set all components upright to air dry.
- Place the hopper upside down so the water can drain out of it.
Cleaning the interior and non-removable components
- Wipe off and disinfect the refrigerator and the bucket (see Fig. 05) with a cloth.
- In particular, wipe off and disinfect the front and back of the filler doors and the entire bucket.
- Carefully wipe all parts dry with a sterile fabric.
Tip:
The filler doors of the bucket are spring-loaded and can be opened by pushing on them carefully.
All parts of the bucket are more easily accessible for cleaning with the filler doors fully open.
Fig. 05: Bucket with filler doors