ELA100 Rev0604
10
INSTALLATION
Install Control Module
1. Measure and mark mounting location for control module panel cutout and
mounting screw holes. Make sure there is clearance behind the panel for the
module and cables before cutting holes. Refer to Figure 2 for layout and
dimensions.
2. Cut out a 3 7/16 by 5 11/16 inch hole.
3. Drill four holes, clearance or tapped, for 10-32 mounting screws.
4. Place control module in position and secure with screws.
5. Connect cables at rear of the control module. (Refer to Wiring section.)
Install Sensors
For most electronic engines, the ThrottleXcel receives engine RPM, oil pressure,
and coolant temperature data over the J1939 databus from the engine ECM. Some
engines do not broadcast this data over the databus and sensors may need to be installed.
The sensors are wired to the 12-pin connector at the rear of the control module.
Refer to the Wiring section (Figure 3) for pinout and wire color information.
An input is provided for an optional transmission temperature sensor.
Install Buzzer
Pin 6 on the 12-pin connector at the rear of the control module is provided to
connect an optional buzzer. Connect the ground side of the buzzer to pin 6. (Maximum
current through pin 6 is 300 mA.) Refer to the Wiring section (Figure 3).
To Next Page
Loading...
Need help?
General
