FRC ThrottleXcel ELA100 - Ford 6.0 L Diesel Harness Connections; 6.0 L Engine Interface

ELA100 Rev0604
28
6.0 L Diesel Engine Interface
An adapter and cable assembly part number ET4106B is needed to interface the
ELA106B with the 6.0 L engine. Two 6 pin connectors are provided and need to be
spliced into the harness between the cab foot throttle and the ECM.
10 Pin
Connector
+12 (24)
VDC
Ignition Key
Cut the five
wires on
the ECM
side of the
10 pin
connector.
RED
BLK
YEL
12
12
12
12
12
+12 (24) VDC
Pump Engaged
Interlock
GND
To Cab
Foot
Throttle
Harness
To Engine
ECM
6 Pin
Deutsch
Plug
6 Pin
Deutsch
Receptacle
8
7
2
4
10
3076 YEL/WH Position Sensor #3
3091 LB/BK Position Sensor #1
3075 YE Position Sensor #2
351 BN/WH +5 Volt Reference
3094 LB/RD Signal Return
6 Pin
Deutsch
Receptacle
6 Pin
Deutsch
Plug
6 Pin Connector
Pin Description
1 Position Sensor #3
2 Position Sensor #1
3 Position Sensor #2
4 +5 Volt Reference
5 Signal Return
6 N/A
Adapter
Assembly
Figure 10. Ford 6.0L ELA106-B Wiring
(Sheet 1 of 2)
RPM Signal Levels IDLE MAX
Position Sensor #1 4.00V 0.60V
Position Sensor #2 1.42V 4.12V
Position Sensor #3 0.88V 3.53V
Do not mount in the
engine compartment