FRC ThrottleXcel ELA100 - Cummins ISB, ISC, ISL Harness Connections; Interface Information; ISB, ISC, and ISL Engine Wiring

ELA100 Rev0604
20
Cummins Harness Connections
Interface Information
The ECM Remote Accelerator (Throttle) Option has to be set to ON. The diagnostic
tool cannot be used to do this, an Insight service tool must be used. Refer to an
authorized dealer to program this option.
ISB, ISC, and ISL Engine Interface
Figure 5. Cummins ELA101 Wiring
(Sheet 1 of 2)
+12 (24)
VDC
Ignition Key
GND
+12 (24) VDC
Pump Engaged
Interlock
8-Pin Cable
(Refer to
Figure 3 )
RED
BLK
ORG
WHT
GRN
YEL
BLU
BRN
12
12
12
12
12
ECM 50-Pin
B Connector
10
REMOTE THROTTLE RETURN (SRTN B)
REMOTE THROTTLE PEDAL POSITION INPUT
REMOTE THROTTLE +5VDC (VSENSOR B)
20
REMOTE THROTTLE ON/OFF INPUT
9
45
6
SELECT THROTTLE CONTROL SWITCH
ECM 50-Pin
J2 Connector
21
ECM Return (Sensor)
Remote Accelerator Position
Sensor Supply
32
Remote Accelerator On/Off Switch
26
03
14
Max Operating Speed/Governor Type Switch
ISB02/ISC03/
ISL03-CM850
Model
Engines