ELA100 Rev0604
14
Display Stored Data
Both the RPM and the message displays are used to show stored data.
Accumulated Hours
Accumulated hours are stored in memory for engine operation, pump operation,
last incident, and current incident. The menu button allows the operator to gain access
to this stored data. When in the accumulated hours mode the RPM display will show
the hours. The message display will show the following:
Pump Operating Hours
Engine Operating Hours
Last Incident Hours
Current Incident Hours
The accumulated hours mode is a display only mode and no changes can be made
to the data.
Press the MENU button to enter the accumulated hours mode.
Stored accumulated hours will be displayed.
The RPM display will show the number of hours.
The message display will show what the hours are for.
Press the MENU button to show the next stored hours.
Each time the MENU button is pressed the displays will change to show the
next block of stored accumulated hours.
Press and hold the MENU button for 5 seconds.
The displays will continuously cycle to show all of the stored accumulated
hours.
Press the SILENCE button to exit the accumulated hours mode.
Fault Warnings
Each time a fault occurs, the type of fault, date, and time are stored in memory.
The memory will hold the last five (5) fault occurrences to be displayed at a later time.
Refer to the Programming section for details on retrieving fault warnings.
Maximum Engine RPM
The maximum RPM that the engine reaches will be stored in the memory to be
displayed at a later time. Refer to the Programming section for details on retrieving
the maximum engine RPM.
To Next Page
Loading...
Need help?
General
