Step 6: Install the optional Remote Control
Panel or LINK instrument ................................ 28
Step 7: Install the Temperature Sensitive
Charging (TSC) sensor, if you are using it ..... 29
Step 8: Check over your unit
to make sure it is properly installed ............... 29
Installation Examples .................................................... 33
Installation Configurations .................................... 33
Installation Option 1 for
Freedom 10, 15, 20, 25 D/D, 30, and 30 D/D ...... 38
Installation Option 2 for
Freedom 10, 15, 20, 25 D/D, 30, and 30 D/D ...... 40
Installation Option 3 for
Freedom 25 D/D and 30 D/D ............................... 43
Installation Option 4 for
Freedom 25 D/D and 30 D/D ............................... 46
Installation Option 5 for
Freedom 15 S/D and 20 S/D ................................. 49
Operation ........................................................................ 51
Selecting the Battery Type ...................................... 52
Reading the Status LEDs ........................................ 53
Troubleshooting LED Status .................................. 54
Power Inverting ............................................................. 56
Turning the Inverter On and Off ........................... 56
Battery Shutdown .................................................... 57
Battery Charging............................................................ 58
Turning the Charger On and Off ........................... 58
Automatic 3-Stage Battery Charging .................... 58
Optional Equalizing Charge .................................. 64
Temperature Sensitive Charging (TSC) ................ 66
Replacing Battery Cable Fuses..................................... 66
Resetting Circuit Breakers ............................................ 67
Specifications .................................................................. 68
To Next Page
Loading...
Need help?
General
