Operation
56
POWER INVERTING
The inverter takes the DC power provided by deep cycle
battery banks, and transforms it to regulated 120 volt AC
power at the crystal controlled, 60 Hz frequency. Your unit is
rated at:
Freedom 10 1000 watts
Freedom 15 & 15 S/D 1500 watts
Freedom 20 & 20 S/D 2000 watts
Freedom 25 D/D 2500 watts
Freedom 30 D/D 3000 watts
The output power is a modified sine wave. It is compatible
with most appliances, tools and other 120-VAC equipment.
Note: Certain laser printers, bread-makers, dimmer lights,
variable speed tools, digital clocks and small battery chargers
may not operate on this type of power.
Turning the Inverter On and Off
To turn the inverter on
• Press the INVERT button on the front of the unit for three
seconds. The green INVERT status light should be solid
green.
• If you are using the Remote Control Panel or the LINK
instrument, you can use it to turn the inverter on.
To turn the inverter off
• Press the INVERT button again. The INVERT status light
will not be lit.
• If you are using the Remote Control Panel or the LINK
instrument, you can use it to turn the inverter off.
Turn the inverter off when you will not be using the unit for
an extended period of time. This reduces battery power
consumption to a very low level.
To reset the unit after correcting a problem
• Press the INVERT button to reset after a fault condition.
To Next Page
Loading...
Need help?
General
