Introduction
4
AC power to go to the loads and helps to prevent the source
AC input circuit breaker from tripping.
The Power Sharing set point is set to factory default of 30
amps. This can be changed using the Remote Control Panel or
LINK instrument.
Inverter Idle Circuit
This automatic, energy saving feature reduces battery power
consumption when you do not have an AC load connected to
the Freedom Inverter/Charger’s output. You can use the
Remote Control Panel or LINK instrument to adjust the idle
threshold. The factory default setting is 5 watts.
To bring the unit out of the idle condition, apply a load.
Response from idle is instantaneous.
Thermostat Controlled Cooling
Your Freedom Inverter/Charger is equipped with a thermo-
statically controlled fan. This cools the unit so it can operate
continually at its rated output.
To Next Page
Loading...
Need help?
General
