25 Locust St, Haverhill, Massachusetts 01830 • Tel: 800/252-7074, 978/374-0761 • FAX: 978/521-1839
e-mail: sales@freqdev.com • Web Address: http://www.freqdev.com
Section 3
9
Model 9002
Installation and Setup
Section 3
Installation and Setup
3.1 - Unpacking and Inspection
When Model 9002 is received, inspect the cartons for visible external damage. If there is obvious physical damage,
we suggest that the carrier’s agent be present during unpacking. Do not destroy the shipment container during
opening so that it may be used for future shipment of the device.
After removing the Model 9002 from the shipping container, examine it for obvious physical damage such as dents,
dislodged components or damaged connectors. If a component is damaged, notify the carrier and follow the instruc-
tions for damage claims.
Warning
DO NOT APPLY POWER TO DAMAGED COMPONENTS. INJURY OR FURTHER
COMPONENT DAMAGE MAY OCCUR.
Inform your Frequency Devices, Inc. representative immediately with specific details about the actual extent of the
damage. Your representative will assist in arranging for repair or replacement of the instrument.
3.2 - Packaging for Shipment
Keep the original shipping cartons. Frequency Devices, Inc. will not accept responsibility for damages in shipment
nor shipping costs if the unit is returned to FDI in an unapproved carton.
Before returning a unit to FDI, you must obtain a Return Authorization (RA) number from FDI.
To pack the Model 9002 for shipment:
1. Tape a tag or letter to the unit identifying the owner and the service or repair to be made.
Include the following information:
RA number
Model number
Serial numbers on the instrument
In any correspondence with us, identify the unit by these numbers.
2. Place the unit in the original carton or request a replacement carton from Frequency
Devices, Inc. (no charge for units in warranty).
3. Secure the carton with strong tape.
4. For international shipments, or if an alternate shipping carton must be used, do the following:
To Next Page
Loading...