Frequency Devices 9002 - Default Chapter; Table of Contents

25 Locust St, Haverhill, Massachusetts 01830 • Tel: 800/252-7074, 978/374-0761 • FAX: 978/521-1839
e-mail: sales@freqdev.com • Web Address: http://www.freqdev.com
Section . . . . . . . . . . . . . . . . . . . . . . . . . . .Page
Preface . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
Warranty & Repair . . . . . . . . . . . . . . . . . . . . . .2
Section 1 - Introduction
1.1 Device Description . . . . . . . . . . . . . . . . . . . . .3
1.2 Applications . . . . . . . . . . . . . . . . . . . . . . . . . .3
1.3 System Interconnection . . . . . . . . . . . . . . . . . .3
Section 2 - Instrument Description
2.1 Front and Rear Panel Controls . . . . . . . . . . . .5
2.2 Input/Output Characteristics . . . . . . . . . . . . . .5
2.3 Filter Properties . . . . . . . . . . . . . . . . . . . . . . . .6
2.4 Specifications . . . . . . . . . . . . . . . . . . . . . . . . .7
2.4.1 Electrical . . . . . . . . . . . . . . . . . . . . . . .7
2.4.2 Physical . . . . . . . . . . . . . . . . . . . . . . . .8
2.4.3 Environmental . . . . . . . . . . . . . . . . . . .8
Section 3 - Installation and Setup
3.1 Unpacking and Inspection . . . . . . . . . . . . . . . .9
3.2 Packaging for Shipment . . . . . . . . . . . . . . . . .9
3.3 Environmental Requirements . . . . . . . . . . . . .10
3.4 Line Voltage . . . . . . . . . . . . . . . . . . . . . . . . .10
3.4.1 System Grounds . . . . . . . . . . . . . . . .12
3.5 Basic Setup . . . . . . . . . . . . . . . . . . . . . . . . . .12
Section 4 - Operation from the Front Panel
4.1 Front Panel Description . . . . . . . . . . . . . . . . .13
4.2 Indicator LED’s . . . . . . . . . . . . . . . . . . . . . . .13
4.3 Function Keys . . . . . . . . . . . . . . . . . . . . . . . .13
4.3.1 Details of the Function Keys . . . . . . . .14
Model 9002
Table of Contents
Section . . . . . . . . . . . . . . . . . . . . . . . . . . .Page
Section 5 - Remote Control Operation
5.1 The Control Method . . . . . . . . . . . . . . . . . . . .19
5.2 Programming Rules . . . . . . . . . . . . . . . . . . . .19
5.2.1 Listen/Talk Structure . . . . . . . . . . . . . .20
5.3 Key-Push Commands . . . . . . . . . . . . . . . . . .20
5.4 Special Command Codes . . . . . . . . . . . . . . .21
5.4.1 Use of Special Code $05,
Abort to Local . . . . . . . . . . . . . . . . . .21
5.4.2 Use of Special Code $06, Set Filter . .22
5.4.2.1 The Code $06 Command Setup . . . . .22
5.4.2.2 Calculating Program Parameters . . . .23
5.4.2.3 Example of a Code $06
Command Setup . . . . . . . . . . . . . . . .26
5.4.3 Code $0B - Go to Channel N,
Filter M . . . . . . . . . . . . . . . . . . . . . . .29
5.4.4 Code $0C - Send Back Channel
Status . . . . . . . . . . . . . . . . . . . . . . . .30
5.4.5 Code $0D - Send Back Channel
Definition . . . . . . . . . . . . . . . . . . . . . .31
5.4.6 Code $0E - Send Back Clip Status . . .32
5.4.7 Code $0F - Go to Remote Control . . .33
5.5 Example of a Remote Control Program . . . . .33
Appendix A - Product Data a Sheet
Appendix B - Binary/Decimal/Hex Review
B-1 Decimal to Binary . . . . . . . . . . . . . . . . . . . . .35
B-2 Binary to Hex . . . . . . . . . . . . . . . . . . . . . . . .36
B-3 Decimal to Hex . . . . . . . . . . . . . . . . . . . . . . .37
Appendix C - Remote Control Programs
C-1 Program 1 . . . . . . . . . . . . . . . . . . . . . . . . . . .38
C-2 Program 2 . . . . . . . . . . . . . . . . . . . . . . . . . . .39
Table of Contents