EasyManua.ls Logo

Frequency Devices 9002 - Figure; Front Panel; Model 9002 in a Typical Setup; Rear Panel

Frequency Devices 9002
43 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
25 Locust St, Haverhill, Massachusetts 01830 • Tel: 800/252-7074, 978/374-0761 • FAX: 978/521-1839
e-mail: sales@freqdev.com • Web Address: http://www.freqdev.com
Section 1
4
Connection of the filter with your system is straightforward; a typical setup is shown in Figure 1.1, below.
Figure 1.1 Model 9002 in a Typical Setup
When operating the filter with a remote controller, care must be taken to follow the programming rules presented in
Section 5 of this manual. In the remote mode, the unit looks at the IEEE-488 bus for its operating commands.
Control of the filters is switched to and from the front panel by depressing a single function key on the panel or by
the appropriate controller commands.
Model 9002
Introduction
Remote Controller
PC< >488
Rear Panel
FDI
Model 9002
Front Panel
Input Output
Signal
Conditioner
Signal
Conditioner
Digitizer
Digitizer
Sensor 1
Sensor 2 Data Out 2
Data Out 1
1
1
2
2
IEEE-488

Table of Contents