Need help?Do you have a question about the Frick QUANTUM Series and is the answer not in the manual?
General| Model | QUANTUM Series |
|---|---|
| Category | Control Panel |
| Operating System | Proprietary |
| Dimensions | Varies by model |
| Display | Touchscreen |
| Connectivity | Ethernet |
| Operating Temperature | 32°F to 122°F (0°C to 50°C) |
| Communication Protocol | Modbus |
| Power Supply | 24 VDC |
| Mounting | Panel Mount |
Steps to configure Quantum for communication.
Wiring instructions for RS-232 connections to Quantum panels.
Guide for converting RS-232 signals to RS-422/RS-485.
Harness setup for RS-422 loopback communication testing.
Harness setup for RS-485 loopback communication testing.
Configuration steps for loopback testing software.
Procedure for executing the loopback communication test.
Overview of supported communication protocols for Quantum controllers.
Step-by-step checklist for establishing communication.
Details on using the proprietary Frick® communication protocol.
Comprehensive guide to Modbus ASCII protocol implementation.
Configuration parameters for SLC-500 for communication.
Configuration parameters for PLC-5/30 for communication.
Logic diagrams for reading data from Quantum controllers.
Logic diagrams for writing data to Quantum controllers.
Table mapping Frick, AB, and Modbus addresses to data points.
Step-by-step guide for configuring HyperTerminal for communications.
Important considerations for successful Quantum™™ communication setup.
Jumper settings for communication on Quantum™™ 3.
Wiring diagrams for Quantum™™ 3 communication ports.
Jumper settings for communication on Quantum™™ 4.
Wiring diagrams for Quantum™™ 4 communication ports.
Wiring diagrams for connecting to remote computers/DCS.
Wiring for lead-lag sequencing between multiple compressors.
Example connection setup for DCS/PLC systems.
Example connection setup for Modbus ASCII.
Example connection setup for Allen-Bradley DF1.
Wiring examples for specific Allen-Bradley applications.
To Next Page
