To Next PageTo Next Page
What to do if the Frick QUANTUM LX keypad does not function as expected?
If the Frick Control Panel keypad isn't working as expected, start by visually inspecting the D8 LED on the control board. Also, check the D6 (Active) LED on the Q5 Interface board. As a troubleshooting step, try using a USB computer keyboard by plugging it into either of the two USB connections on the controller.
General| Communication Ports | Ethernet, USB, Serial, CANbus |
|---|---|
| Processor | Intel Atom E3845 |
| Connectivity | Ethernet, USB, Serial, CANbus |
| Operating Temperature | 32° to 122°F (0° to 50°C) |
| Humidity Range | 5% to 95% RH, non-condensing |
Overview of the Quantum™ LX control panel and its hardware versions.
Details on Ethernet setup, cabling, and components for network connectivity.
Explanation of RS-232, RS-422, and RS-485 serial communication protocols.
Configuration steps for serial communication ports on the Quantum™ LX.
List of supported serial protocols and setup checklist.
Programming examples for reading/writing data with Allen-Bradley processors.
Details on channel configuration and programming logic for AB communication.
Overview of Modbus protocol, its implementation, and usage with Quantum™ LX.
Specifics on using Modbus over TCP/IP for Ethernet communication.
Details on Modbus ASCII transmission mode for serial communication.
Details on Modbus RTU transmission mode for serial communication.
Introduction to HyperTerminal as a terminal emulation program.
Step-by-step guide to configuring HyperTerminal for communication.
Procedures for verifying communication links using HyperTerminal.
Table listing Analog Board values accessible for reading.
Table listing Digital Board values accessible for reading.
Table listing Calculated Values accessible for reading.
Table listing various Mode values accessible for reading.
List of address ranges corresponding to warning and shutdown messages.
Identification and description of the Q5 processor board and its features.
Pictorial showing customer connection points for serial and Ethernet.
Details on serial communication hardware and ports on the Q5 controller.
Wiring diagrams and jumper settings for serial communication ports.
Troubleshooting tips for RS-232, RS-422, and RS-485 communications.
Identification and description of the Q4 processor board and its features.
Details on serial communication hardware and ports on the Q4 controller.
Wiring diagrams and jumper settings for serial communication ports on the Q4.
Procedures for performing loopback tests on serial communication ports.
Details on the Frick serial communications converter module and its setup.
Wiring diagrams for Quantum™ LX Ethernet communication setup.
Diagrams illustrating typical local Ethernet configurations.
Diagrams illustrating typical network Ethernet configurations.
Wiring diagrams for Quantum™ LX serial communication setups.
Visual diagrams for RS-485 and RS-422 communication wiring.
