Frick QUANTUM LX - E-Mail Data; Protocols

QUANTUM
™
LX EVAPORATOR CONTROL PANEL
COMMUNICATIONS SETUP
090.610-CS (MAY 2016)
Page 11
upper and lower case letters. It is similar in concept to
the function of the Panel ID, and basically allows the
network router to interpret the actual IP address of a
particular unit as this host name. When using a web
browser within the system network, this name can be
entered as the web location that you wish to visit (in-
stead of having to type in the IP address). After modi-
fying a Host Name, you will be required to cycle power.
The network router could take up to fteen minutes to
recognize the change.
Work Group – All of the Quantum™ LX units within
a network may be grouped into different categories.
These categories could be unit locations, or perhaps
categorized by unit function. For instance, if you want-
ed to group the units by function, and had 10 units, and
three of them were Evaporators (located on the roof),
then Evap1 could be the name of a work group. So
name each unit by these functional Work Group names.
The Work Group name must be fteen characters or
less in length, and can use numerals and upper and
lower case letters. When using the network neighbor-
hood feature of Windows® Explorer, by looking at your
Network Neighborhood, you would see the name of the
Work Group, and within that work group you would see
the individual Host Names of each unit within that work
group. After modifying a Work Group name, you will be
required to cycle power. The network router could take
up to fteen minutes to recognize the change.
Server String – This is a comment area that can be
used in conjunction with the Host Name. For example,
if the Host Name is Booster1, you could set the Server
String to print something like DockBooster, or some
other additional information about the unit. The Server
String has no control function; it is strictly an informa-
tional area.
E-MAIL DATA
The purpose of the E-Mail data feature is to allow the
controller to send a Warning or Shutdown message to
dened listing of recipients.
Email Notication On Warning Or Shutdown – For the
E-mail notication feature to work, it must be enabled
(it is disabled as a default). The following drop-down
menu is provided:
• Disabled
• Enabled
Local Email Address - Use this setpoint box to enter
a valid E-mail address that has been assigned to the
internet account.
Alias Name For Local Email Address – Enter here a
custom name to identify more clearly the local Email
address. When a message is sent to all recipients, this
is the name that will appear in the Email FROM column.
Subject - Enter a custom subject that you would like to
appear when a message failure is sent. When a mes-
sage is sent to all recipients, this is the wording that
will appear in the Email SUBJECT column.
SMTP Server Name OR IP Address - SMTP stands for
Simple Mail Transfer Protocol. SMTP servers handle
outgoing email, and accept email from other domains.
When you set up an email client, you must specify an
outgoing server (sometimes called an SMTP server).
Often, this server is designated in the form of smtp.
domain.com. But this can vary, so be sure to check
with your email service provider or LAN administrator
to nd out their outgoing server.
SMTP Server Port Number - This value is in almost all
cases going to be 25. This should be set by the network
or LAN administrator.
Comma-Delimited List Of Email Recipients - This is
simply the list of the Email addresses that you would
like to have any messages sent to. Separate each e-
mail address with a comma.
PROTOCOLS
The purpose of this section is to enable or disable the
Modbus TCP and Ethernet/IP parameters.
Modbus TCP:
• Disabled
• Enabled
Ethernet/IP:
• Disabled
• Enabled