Safety
Froling GmbH, Industriestraße 12, 4710 Grieskirchen, AUSTRIA Page 15
www.froling.com B0600008_US
For safety keep all Boiler Doors and Ash-Pit Doors and all Covers tightly
closed during operation!
Do not operate with flue draft exceeding 0.10 inches in water column (25
Pa), if no Draft Regulator is installed!
Do not store fuel, clothing, furniture or other combustible material within
marked installation clearances within boiler is installed!
Faulty operating conditions not complying with Owner’s Manual, such as
insufficient combustion air, incorrect or insufficient cleaning and mainte-
nance or non-permitted fuel could result in Danger of Life or Severe Injury
caused by serious faults in combustion (e.g. spontaneous combustion of
wood gases or flash fires)!
Inspect and clean Boiler, Flue Gas Pipe and Chimney regularly!
The Heat Exchanger, Induced Draft Fan, Flue Gas Pipe, and Chimney must
be cleaned regularly to remove accumulated creosote and ash. Ensure that
the Heat Exchanger, Flue Gas Pipe, and Chimney are cleaned at the end of
heating season to minimize corrosion during the summer months.
First firing during start-up of boiler system shall be carried out in accord-
ance to Instruction Label at Fuel Loading Chamber Door and in attendance
of an authorized installer or manufacturer’s representative only! Disregard-
ing of warning may cause damage or explosion of Combustion Chamber
and severe injuries unfavorably!
Gas created during solid-fuel combustion may cause a small flash when the
boiler is refueled if not properly vented!
Hot parts and the Flue Gas Pipe can cause serious burns!
Unauthorized access to the boiler room could result in personal injury and
damage to property!
Always use protective gloves while loading boiler or carry out other work on
boiler!
Always use Control Handles when opening Boiler Doors!
Do not touch Flue Gas Pipe during operation!
Do not carry out maintenance when the boiler is hot!
Do not touch hot surfaces behind Insulation Door!
To Next Page
Loading...
Need help?
General