3 Operating the system
3.1 General information
IMPORTANT: First start up of boiler system shall be carried out only
in attendance of an authorized installer or manufacturer’s
representative
The individual steps for first startup are explained in the
installation manual
During normal operation of boiler all surfaces and control handles behind
insulation door get hot. Touching hot surfaces can cause serious burns!
Additionally there is the risk of injuries by splinters of fire wood!
When heating up or refueling the boiler:
Always wear protective gloves
Always use control handles for open boiler doors
3.1.1 Preparing fire wood
Prepare the necessary amount of fuel within boiler area before opening
boiler doors. For usability and preparation of fire wood; pay attention to
chapter 2.2 within this manual.
For details refer to chapter 2.2.1 Permitted fuel
3.1.2 Main Switch at Boiler Control System
Check the Main Switch at the right hand
side of the boiler
Switching off the Main Switch when boiler is
hot will cause explosive gases!
Avoid switching off Main Switch at Boiler Control System during
heating season!
In case Main Switch was switched off switch it on and wait for at
least 15 minutes before continuing!
3.1.3 Error status of Boiler Control System
Check the Status LED at Boiler Control Display unit for activated and
error free system (green flashing light)
In case any error message is displayed at Boiler Control System
(red flashing light at Status LED) or display is blank refer to
chapter 6 "Troubleshooting"
Do not open any Boiler Door before error is cleared!
Refrain from fueling!
To Next Page
Loading...
Need help?
General