3.2 When do you need to heat up or refuel your boiler
Check the Thermal Storage loading status symbol at the display unit
to see how much energy you have in your Thermal Storage System
No dash or one dash visible in loading status symbol:
You can fill up the Fuel Loading Chamber completely
and set fire.
Three or four dashes in loading status symbol:
Do not heat up or recharge the boiler! The Thermal
Storage System is still too hot to store additional
amount of energy
3.2.1 Inspect the burning flame
Because opening the Combustion Chamber Door during heating is dan-
gerous and destructive to the boiler, there is not a possibility to watch
the burning flame by means other than the ash door viewing window:
Open the Insulation Door
Do not open any other Boiler Door!
Cautiously turn rotary slide cover at Combustion Chamber Door to
get sight glass into visible position
Watch Combustion Chamber through sight glass
Cautiously turn rotary slide cover at Combustion Chamber Door back
to get sight glass into covered position and close Insulation Door
again
To Next Page
Loading...
Need help?
General