31
EN
TIG Comfort Stop Activating and setting the TIG Comfort Stop function is described in "The Setup menu" sec-
tion.
Welding
During welding, raise the welding torch
- The arc length is increased significantly
Lower the welding torch
- The arc length is decreased significantly
- This triggers the TIG Comfort Stop function
Keep the welding torch at the same height
- The welding current continually decreases (downslope) until the arc goes out
Wait for the gas post-flow time to finish and lift the welding torch away from the work-
piece
Welding current and gas flow curve with TIG Comfort Stop function activated
(1) Gas pre-flow
(2) Gas post-flow
1 2 3 4 5+
1
2
3
4
5
t
tdown
I
Max. A
70 A
(1)
(2)
1 2
3 4 5+
To Next Page
Loading...
