111
EN
Wire-stick control
function
The wire-stick control function is available if a robot interface or field bus system is con-
nected to the LocalNet.
After the end of welding, the wire-stick control function detects any “sticking” of the wire
electrode in the solidifying weld pool. If a sticking wire electrode is detected within 750 ms
after the end of welding, the error message “Err | 054” will be output.
Procedure in the event of a sticking wire electrode:
Cut off the end of the wire electrode that is sticking
The power source is now ready for operation.
Changing the
welding process
during CMT Ad-
vanced welding
To change the welding process or characteristic:
first, end the CMT Advanced process
wait 300 - 600 ms
Another welding process or characteristic can be selected during this time.
Resume the welding process with another welding process or characteristic
WARNING! A welding process that starts automatically can pose a risk to life.
The “Arc on” signal must not be set while the error is being rectified, otherwise
welding will start as soon as the error is rectified.
NOTE! The error message “Err | 054” does not need to be acknowledged.
NOTE! The standard factory setting is that the wire-stick control function is not ac-
tivated. If required, activate the wire-stick control function in the "Setup menu -
level 2" (“Stc | ON”).
1
NOTE! Neither the welding process nor the currently selected characteristic can
be changed during CMT Advanced welding.
1
2
3
To Next Page
Loading...
Need help?
General
