Maintenance Before each start-up, check the mains plug and mains cable and charging cables
and charging terminals for damage.
If dirt accumulates on the device, clean the surface of the device housing with a
soft cloth and only with solvent-free cleaning agents.
Maintenance and
repair
Maintenance and repair work must only be carried out by authorised personnel.
Use only original spare and wearing parts (also applies to standard parts). It is
impossible to guarantee that bought-in parts are designed and manufactured to
meet the demands made on them, or that they satisfy safety requirements.
Modifications, installations or conversions are only permitted with the approval
of the manufacturer.
Warranty and li-
ability
The warranty period for the charger is 2 years from the date of invoice.
However, the manufacturer will not accept any liability if the damage was caused
by one or more of the following:
-
Use of the charger "not in accordance with the intended purpose"
-
Improper installation and operation.
-
Operating the charger with faulty protection devices.
-
Non-compliance with the operating instructions.
-
Unauthorised modifications to the charger.
-
Catastrophes caused by the activities of third parties and force majeure.
Obligations of
the operating
company
The operating company must only allow persons to work with the device who:
-
Are familiar with the fundamental instructions regarding safety at work and
accident prevention and have been instructed in how to use the device
-
Have read and understood these Operating Instructions, especially the
"Safety rules" section and have confirmed as much with their signatures
-
Are trained to produce the required results.
Checks must be carried out at regular intervals to ensure that operators are
working in a safety-conscious manner.
Safety inspec-
tion
The manufacturer recommends that a safety inspection of the device is per-
formed at least once every 12 months.
The safety inspection may only be performed by an appropriately qualified elec-
trician
-
After any changes have been made
-
After any additional parts are installed, or after any conversions
-
After repair, care and maintenance are carried out
-
At least every twelve months
For safety inspections, follow the appropriate national and international stand-
ards and directives.
Further details on safety inspections can be obtained from your service centre.
They will provide you on request with any documents you may require.
7
To Next Page
Loading...
Need help?
General
