EasyManuals Logo

Fronius Smart Meter IP User Manual

Fronius Smart Meter IP
60 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #43 background imageLoading...
Page #43 background image
Location of the primary meter at the feed-in point. *Terminating resistor R 120 Ohm
The following must be observed in a multi-meter system:
-
Connect the primary meter and the battery to different channels (recom-
mended).
-
The remaining Modbus participants must be distributed evenly.
-
Only assign each Modbus address once.
-
Terminating resistors must be positioned individually for each channel.
43

Table of Contents

Other manuals for Fronius Smart Meter IP

Preview: Quick Start Guide
Quick Start Guide4 pages

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fronius Smart Meter IP and is the answer not in the manual?

Fronius Smart Meter IP Specifications

General IconGeneral
BrandFronius
ModelSmart Meter IP
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals