Fronius Symo 10.0-3-M Installation Instructions

Installation location and position
Explanation of
safety notices
DANGER!
Indicates immediate danger.
▶
If not avoided, death or serious injury will result.
WARNING!
Indicates a potentially hazardous situation.
▶
If not avoided, death or serious injury may result.
CAUTION!
Indicates a situation where damage or injury could occur.
▶
If not avoided, minor injury and/or damage to property may result.
NOTE!
Indicates a risk of flawed results and possible damage to the equipment.
Safety
WARNING!
Danger due to incorrect operation and incorrectly performed work.
This can result in serious injury and damage to property.
▶
Only qualified personnel are authorised to commission your inverter and only
within the scope of the respective technical regulations.
▶
Read the Installation and Operating Instructions before installing and com-
missioning the equipment.
WARNING!
Danger due to work that has been carried out incorrectly.
This may result in serious injury and damage to property.
▶
Surge protective devices must only ever be installed and connected by a
qualified electrical installation engineer!
▶
Follow the safety rules.
▶
Ensure that both the AC side and the DC side of the inverter are de-ener-
gised before carrying out any installation and connection work.
5
EN

Fronius Symo 10.0-3-M Specifications

General

Max. output current	16.7 A
Max. input voltage	1000 V
MPP voltage range	200 - 800 V
Number of MPP trackers	2
Protection class	IP 65
AC voltage range	150 - 280 V
Frequency	50 / 60 Hz
THD	< 3 %
AC Nominal Power	10000 W
MPPT Voltage Range	200 - 800 V
AC Frequency	50 / 60 Hz
AC nominal output	10000 W
Max. apparent AC power	10000 VA
DC input voltage range	200-1000 V
Operating Temperature	-25°C to +60°C
Dimensions (W x H x D)	725 x 510 x 225 mm
AC nominal voltage	3 x 230 / 400 V