Fronius TransSteel 2200 - Replacing the Fan

Replacing the fan
Replacing the fan
(1)
(2)
1
Open left side panel
2
Undo the TX25 screw (1) and remove
the cover (2)
(4)
(3)
3
Remove the fan (3) and unplug the
connector (4)
4
Connect and install the new fan
IMPORTANT!
Install the fan with the air flow towards
the inside.
The arrow on the fan should point inwards.
(6)
(5)
5
Insert the cover (5) and fit an M5x12
mm TX25 screw (6)
Tightening torque = 3.0 Nm
6
Close left side panel
32