Fronius TransSteel 2200 - Installation and Initial Operation

Installing the
motor plate
(2) (3)
(1) (2) (3)
1
Align the holes (2) on the motor plate
(1) with the locating pins (3) in the
power source
2
Gently push the motor plate (1) in until
it engages
(5)
(4)
3
Fit the motor plate using three TX25
screws (4)
Tightening torque = 1.5 Nm
4
Position the drive in the motor plate
and fit using three M5x12 mm PH2
countersunk screws (5)
Tightening torque = 2.1 Nm
5
Fit the wearing parts and close the
cover
(6)
(6)
6
Fit two TX25 screws (6)
Tightening torque 2.1 Nm
41
EN