Fronius TransSteel 2200 - Replacing the Motor Plate; Removing the Motor Plate

Replacing the motor plate
Removing the
motor plate
(1)
1
Open housing as described in section
"Opening the housing"
2
Remove the wearing parts from the
motor plate
3
Undo the TX25 screw (1) on the polar-
ity reverser lead
(2)
(2)
4
Undo the two TX25 screws (2)
(3)
(4)
5
Undo the three PH2 screws (3)
6
Undo the three TX25 screws (4)
7
Swivel the motor plate outwards and
remove it
40