Fronius TransSteel 2200 - General Setup, Safety, and Intended Use

Closing the housing
Closing the hous-
ing
(1) (1)
1
Insert the control panel
2
Fit the control panel using two PT
5x14 mm TX25 screws (2)
Tightening torque = 1.5 Nm
(2)
(1)
3
Connect the ribbon cable (2) for the
control panel to the LSTMAG20 PC
board
(3) (3)
(3)(3)(3)
4
Insert the side panel and secure using
five M5x12 TX25 screws (3)
Tightening torque = 2.1 Nm
43
EN