Software update
Software update The operating system and the welding process database are constantly being enhanced.
The power source operating system and the welding process database can be updated
separately using the LocalNet USB converter. The latest programs can be downloaded
from the DownloadCenter.
To update the software on the power source, the TSt2500c remote control cable harness
(43,0004,4850) is required in addition to the LocalNet USB converter. The cable harness
must be connected between the LocalNet USB converter and the LSTMAG20 PC board.
1
Connect the TSt2500c remote control
cable harness (43,0004,4850) to the
update interface (1)
2
Connect the LocalNet USB converter
to the cable harness and PC board
3
Perform the firmware update
51
EN
To Next Page
Loading...
