Fronius TransSteel 2200 - Mtg2100 S Fsc

MTG2100S FSC
(1)
(2)
(1)
(1) (1)
1
Undo the four 2.5x12 mm TX 10
screws (1) and open the FSC
2
Disconnect the coaxial cable using a
15 mm flat spanner (2)
(3)
3
Unpin the control lines (3)
IMPORTANT!
When unpinning the control line, note
the position of the tool to fully undo the
locking hooks.
(4)
(5)
4
Fit the new coaxial cable/FSC using a
torque wrench (42,0411,9040) with
insertion tool (42,0435,0229) (4)
Tightening torque = 15 Nm
5
Allow the control line to engage using
a pinning tool or flat screwdriver (5)
Brown A
Blue B
NOTE!
Pull to check that the locking hooks on
the control line are engaged
45
EN