Fronius TransSteel 2200 - Device Connections: Front, Rear, and Side Views

Installing the
drive
(1)
1
Insert the drive (1)
(2)
2
Fit the drive using three PH2 screws
(2)
Tightening torque = 2.1 Nm
(1)
3
Plug in the motor lead (3) on the LST-
MAG 20 PC board
4
Fit the driver roller and pressure roller
5
Calibrating the motor
6
Close housing as described in section
"Closing the housing"
Calibrating the
motor
Access the Service menu à Select the "2nd" parameter and access the second Service
menu.
38