10
REMOTE
(3)
(2)
(1)
“Remote” control panel
The “Remote” control panel is fitted as standard as part of the power source. The power
source is operated from the control panel on the wire-feed unit.
The remote power source can be operated via the following system add-ons:
- remote control units
No. Function
(1) Overtemperature indication
lights up if the power source overheats (e.g. because the duty cycle has been
exceeded). For more information, refer to the „Troubleshooting“ section.
(2) Error indication
lights up if an error has occurred. All the units which are connected to the LocalNet,
and which have a digital display, support the display of the relevant error message.
(3) Power source ON indication
lights up when the mains cable is plugged into the mains and the mains switch is in
the - I - position
“Remote” control panel
General
“Remote” control
panel
To Next Page
Loading...
